Programming:

The EB10 Electronic ballast is delivered without lamp parameters, you can create a ballast to your demands.
By connecting the eb10 to the computer you can load a specific parameter in to each channel of the eb10.

Example:
You have a solarium with 48 lamps, 24 in the top and 24 in the bottom
In the top the lamps are 160Watt and in the bottom 100Watt.

How to handle:
1)   install 5 eb10's in the solarium
2)   set dipswitches of each ballast as a RS422 bus number
3)   connect the ballasts to the computer
4)   load the parameters for the 100Watt lamps and program them into the ballast
5)   repeat this for the 160Watt lamps
6)   run tests via the eb10 configuration application including dimming facilities
7)   disconnect the computer
8)   run your solarium